Rhino Lining/Line X

[tstickler]

I was wondering if anyone could recommend a place in the Elkhart area that does Line X or some other type of lining? I am looking at coating my bumpers, light bar and rock sliders. I got a quote from Line X in Angola for $750 bucks and that seems kinda high to me considering you can get an entire truck bed done for around $500.

Any suggestions would be greatly appreciated.

Thanks!

Tim

[airforceret]

I had my bedliner done by Dan's Service Center there on the north side of Elkhart. They do a great job at a reasonable price. I've got a slide in camper with several thousand miles traveling to Moab and back now with no issues!!! I've hauled my ATV and ramps a few times now, and other stuff from Home Depot... still looks great!

Tell Nate or any of them that Roger (the jeep guy) sent you! LOL Roger

[svtkev]

no joke, the rust-oleum truck bed coating is super tough and way cheaper than rhino lining,i did my entire cage and bumpers with it , cant tell a difference between the stuff i spray bombed and the stuff i paid out the wazoo to have powder coated lol, this stuff right here, lowes carrys it

[sandfox]

in spray can, i have used a lot of the duplicolor tr250 bed liner, it is super tough, i refurb jeep mirrors and paint them with it, i have done multiple bumpers and sliders that even after 2 years still look great, just did the rear frame and bumper on my wrangler, i have also sprayed herculiner, monstaliner, shake and shoot, marson bedliner, probably some others, if you prep it ,i would help ya spray it

[aquaman]

I've used the Rust-Oleum bed liner on a couple bumpers and some rock rails it looked great, it's something that can easily be done at home, it's durable, and it's cheap.

[speeduck]

i have also had good luck with using the duplicolor spray on bedliner @12 bucks a can it costs, but my stuff looks great and has been durable so far! big R

[tstickler]

Thanks for the advice everyone. I may just go to Lowe's and pickup a couple of cans of the Rust-oleum bedliner and try it out on one of my sliders to see how it looks. If it turns out well I will just do it all myself then.

I appreciate the offer sandfox.....I may go ahead and take the sliders off tonight and start blasting them. I'll let you know if I need any help.